EGW (49313) Glock Red Dot Mount Vortex Viper /Venom /Burris Fastfire /Docter

$114.99

EGW (49313) Glock Red Dot Mount Vortex Viper /Venom /Burris Fastfire /Docter

Are you looking to replace your factory Glock rear sight with a red dot mounting plate? Our red dot adapter plates for Glocks easily let you mount your red dot to your gun with no modifications to the slide! Our Glock red dot sight mounts are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.

Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. These dots may not fit properly on the posts on the plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.

*All UTG/ADE mounts require 6-32 x 3/8″ screws (Not Supplied).

This mount fits all generation Glocks with only rear sight dovetail cuts:
(including but not limited to)
Glock 17, Glock 17L, Glock 21, Glock 22, Glock 34, Glock 35, Glock 41, Glock 42 (Our mount is wider than the slide, but it will still work), Glock 43 (Our mount is wider than the slide, but it will still work), Glock 43x (Our mount is wider than the slide, but it will still work), Glock 44, Canik TP9 SF, Canik TP9 SA

Does not fit ANY/ALL Glock MOS models.
Does not fit ANY/ALL Glock slides that are already cut for optics.
This mount will also fit the NON-optics ready PSA DAGGER